Door Handle Wraps for Rivian R1T & R1S
Each handle wrap will just take a minute to install, watch the video below for a quick guide. Try to install when the temperature is between 60-80f (15-27c), so that the vinyl is easy to work with.
Find all of our Installation guides for the amazing Rivian R1T and R1S right here!
Each handle wrap will just take a minute to install, watch the video below for a quick guide. Try to install when the temperature is between 60-80f (15-27c), so that the vinyl is easy to work with.
Allow yourself an hour or so to install the full kit. watch the video below for a quick guide. Try to install when the temperature is between 60-80f (15-27c), so that the PPF is easy to work with.
Allow yourself half an hour or so to install the full kit. watch the video below for a quick guide. Try to install when the temperature is between 60-80f (15-27c), so that the PPF is easy to work with.
Allow yourself at least an hour to install, and have a second helper available to assist with the initial positioning of each piece. Please watch the video below for a quick guide. Try to install when the temperature is between 60-80f (15-27c), so th
Allow yourself about half an hour to install, and watch the video below for a quick guide. Try to install when the temperature is between 60-80f (15-27c), so that the PPF is easy to work with.
If you purchased just the top section, allow 20 minutes for the installation, for both sections, it'll be nearer an hour. Please watch the video below for a quick guide. Try to install when the temperature is between 60-80f (15-27c), so that the PPF
If you purchased just the smaller bottom section, allow around 15 minutes for the installation, for both sections, it'll be nearer an hour, and try to solicot some help for the larger piece, as it can be a little unwieldy for one person to handle. Pl
Please watch the video below, it's about 23mins long, so use the the chapter markers for navigation. We'd be remiss if we didn't say one thing - watch out for the dust 👀!.
Please refer to the quick video below for how to install. As always, try to install when the temperature is in the 60-80f/16-27c range.
Each logo will take just a minute to install, don't forget, you need to provide your own center (hub) caps. As soon as we have some recommendations on those available on Amazon, we'll post a link here.
Please watch the video below for a quick guide on how to install them, and please note the following care instructions:. 1. Do not jet-wash your wheels. 2. Do not use harsh chemicals to clean your wheels (i.e. brake dust remover). 3. When hand-washin
Please watch the video below for a quick guide on how to install them, and please note the following care instructions:. 1. Do not jet-wash your wheels. 2. Do not use harsh chemicals to clean your wheels (i.e. brake dust remover). 3. When hand-washin
Allow just a few minutes to prep and install, and try to install when the temperature is between 60-80f (15-27c), so that the vinyl is easy to work with.
Please watch the video below to see how to install the Frunk and Gear Tunnel lights:.
Please refer to the video below:.
Please refer to the video below. Please note, the vinyl we use (3M 2080) has a very thin clear, protective layer. We try to keep it in place, but sometimes it'll come away when we're cutting the vinyl. If it's there, don't worry if you notice a thin
Please watch the video below, and note the following:.