XPel Armor Sill ProtectionUpdated a month ago

Please watch the quick video below.

If the Armor is curled after shipping, just lay it out flat(ish) for a few minutes and it'll soon flatten out.

Bellow follows an AI-generated step-by-step instructions.

1. Clean the area: Use an alcohol wipe to clean the area where you will be installing the Armor Sill Protection. Make sure to remove any dirt, dust, or debris.
2. Align the Armor Sill Protection: Align the Armor Sill Protection with the edge of the Cybertruck's sill. The lower corners of the Armor Seal Protection should be aligned with the rounded corners of the sill.
3. Apply the Armor Sill Protection: Peel back the backing of the Armor Sill Protection and slowly apply it to the sill. Use your fingers to smooth out any wrinkles or bubbles.
4. Trim any excess: If there is any excess Armor Sill Protection, use a trim tool to cut it off.
5. Repeat for the other side: Repeat steps 1-4 for the other side of the Cybertruck.

Additional Tips:

• If you make a mistake, you can easily remove the Armor Sill Protection and reapply it.
• The Armor Sill Protection is designed to be tough and durable. It can withstand oil, grease, and other harsh chemicals.
• The Armor Sill Protection is also easy to clean. Simply wipe it down with a damp cloth.

Here are some additional details from the video:

• The Armor Sill Protection is 23 mil thick, which is much thicker than typical PPF.
• The Armor Sill Protection has a textured finish that is similar to the spray-on bedliner finish on the Cybertruck.
• The Armor Sill Protection is easy to install and does not require any special tools.