Xpel Armor for Wheel FlaresUpdated 25 days ago
Please refer to the video below and use the chapter markers to jump to the section you need.
If the Armor is curled after shipping, just lay it out flat(ish) for a few minutes and it'll soon flatten out.
Bellow follows an AI-generated step-by-step instructions.
Step 1: Prepare the Installation Area
- Clean the trim: Wipe down the wheel flare trim with alcohol spray to remove any dirt, grime, or residue from cleaners like Armor All.
- Choose your starting point: The video recommends starting with the front wheel flares as they have fewer pieces.
Step 2: Install the Front Wheel Flares
- Start with Section A:
- Peel off the backing from Section A, starting from a corner.
- Align the top edge of the piece with the top edge of the trim, ensuring it doesn't cover the radius of the corner.
- Use the squeegee to smooth out any air bubbles and adhere the piece to the trim.
- Install Section B:
- Align the edge of Section B with the edge of Section A.
- Apply pressure and use the squeegee to adhere it to the trim.
- Install Section C (Camera Section):
- Align the back edge of Section C with the back edge of the trim.
- Carefully work around the camera cutout, ensuring the piece adheres properly.
- Use the squeegee to remove any air bubbles.
- Install Section D:
- Align the edge of Section D with the edge of Section C.
- Tuck the "leg" of Section D under the trim.
- Use the squeegee to adhere the piece to the trim.
Step 3: Install the Rear Driver's Side Wheel Flares
- Start with Section (varies):
- Choose a starting section and align it with the trim, ensuring proper placement.
- Use the squeegee to adhere the piece to the trim.
- Continue with the remaining sections:
- Install the remaining sections (T, Q, S, and O) in order, aligning each piece with the previously installed section.
- Use the squeegee to remove any air bubbles and ensure a secure bond.
- Install the Charging Door Section:
- Align the main piece of the charging door section with the trim.
- Close the charging door to ensure proper fit.
- Use the squeegee to adhere the piece to the trim.
- Install the small strip above the charging door.
Step 4: Install the Rear Passenger Side Wheel Flares
- Start with Section N:
- Align the edge of Section N with the trim and adhere it using the squeegee.
- Continue with the remaining sections:
- Install the remaining sections (M, L, K, and J) in order, aligning each piece with the previously installed section.
- Use the squeegee to remove any air bubbles and ensure a secure bond.
Step 5: Install the Front Passenger Side Wheel Flares
- Start with Section E:
- Align the top edge of Section E with the top edge of the trim.
- Use the squeegee to adhere the piece to the trim.
- Install Section F:
- Align the edge of Section F with the edge of Section E.
- Use the squeegee to adhere the piece to the trim.
- Install Section G (Camera Section):
- Align the back edge of Section G with the back edge of the trim.
- Carefully work around the camera cutout, ensuring the piece adheres properly.
- Use the squeegee to remove any air bubbles.
- Install Section H:
- Align the edge of Section H with the edge of Section G.
- Use the squeegee to adhere the piece to the trim.
Tips and Troubleshooting:
- Take your time: This is a meticulous process. Don't rush it.
- If you encounter bubbles: Gently peel back the affected area and re-adhere it, smoothing out any air bubbles with the squeegee.
- If the trim is misaligned: Peel back the affected section and re-position it correctly.
- If the pieces are difficult to work with: It might be too hot. Work in a cooler environment or wait for the material to cool down slightly.