Xpel Armor for Rocker PanelsUpdated 2 days ago

please refer to the video below.

If the Armor is curled after shipping, just lay it out flat(ish) for a few minutes and it'll soon flatten out.

Here is a step-by-step tutorial on how to install the expel armor protection for the rockers on your Cybertruck, based on the provided video:

Kit Overview

• The kit includes driver and passenger side sections, an instruction sheet, and a squeegee [01:35].
• The armor has a spray-on truck liner texture and enhances the Cybertruck's trim [00:47].

Surface Preparation

• Ensure the surface is clean, especially if trim enhancers have been used [01:52].
• Use alcohol or soapy water to remove grease and wax [02:05].

Installation Steps

1. Remove the Tesla mud flaps, if installed [02:21].
2. Spray down the surface to ensure it is clean [03:07].
3. Install in alphabetical order, starting with piece 'A' [03:49].
4. Align each piece carefully, matching seams and edges [05:38].
5. Use the squeegee to apply pressure and remove bubbles [05:18].
6. For longer pieces, like 'D' and 'E', align the top edge and work your way down [08:20], [10:44].
7. Ensure no tension when tucking in edges [12:14].
8. Maintain a symmetrical gap of about 5mm between pieces [13:24].
9. For the final piece, 'G', align with the existing section and ensure proper placement under the door [14:31].

Additional Tips

• Lifting the truck can make the installation easier [10:05].
• Install inside to prevent dust from getting underneath the PPF [09:02].
• Consider armor protection for the area above the rocker panels as well [13:51].