Xpel Armor for Mirrors

Please refer to the quick video below, there's some nuance to this kit vs. some of the other Xpel Armor kits. As always, try to install in the sun if possible, but if not, when the temperature is at least 60f/16c.

Below follows an AI generated step by step instructions.

Step 1: Preparation

Clean the Mirror: Thoroughly clean the mirror surface to remove any dirt, bugs, or other debris. Use a mild soap and water solution, followed by a final wipe with alcohol to remove any remaining residue.

Step 2: Install the Strip

Locate the Strip: Identify the strip piece in the kit. This piece acts as an alignment guide.
Position the Strip: Peel back the backing of the strip and carefully position it along the bottom edge of the mirror, ensuring it is aligned correctly.
Squeegee the Strip: Use the squeegee to firmly adhere the strip to the mirror, removing any air bubbles.

Step 3: Install the Main Piece

Position the Main Piece: Peel back the backing of the main piece and carefully position it over the mirror, aligning the top edge with the previously installed strip.
Stretch and Adhere: Gently stretch the main piece to ensure it conforms to the curves of the mirror. Use the squeegee to firmly adhere the piece, working from the center outwards to remove any air bubbles.
Address Bubbles: If any stubborn bubbles remain, carefully peel back the film and re-adhere it, smoothing out the wrinkles.

Step 4: Install the Top Piece

Position the Top Piece: Peel back the backing of the top piece and carefully position it over the mirror, aligning the edges with the previously installed pieces.
Adhere the Top Piece: Use the squeegee to firmly adhere the top piece, working from the center outwards to remove any air bubbles.
Address Bubbles: If any stubborn bubbles remain, carefully peel back the film and re-adhere it, smoothing out the wrinkles.

Step 5: Final Inspection

Check for Gaps: Inspect the installed armor for any gaps or misalignments. If necessary, gently peel back the film and reposition it for a better fit.
Enjoy the Results: Admire your newly protected Cybertruck mirrors!

Additional Tips:

Work in Sunlight: Installing the armor in direct sunlight can help with the adhesion process.
Take Your Time: Don't rush the installation process. Take your time to ensure proper alignment and adhesion.
Address Bubbles Promptly: If any bubbles appear after installation, address them promptly to prevent them from becoming permanent.

Xpel Armor for MirrorsUpdated 3 days ago