Abstract Ocean Help Center logo
Abstract Ocean Help Center logo

All articles

Xpel Armor for Bed TrimUpdated 2 days ago

Please watch the videos below.

If the Armor is curled after shipping, just lay it out flat(ish) for a few minutes and it'll soon flatten out.

Bellow follows an AI-generated step-by-step instructions.

Step 1: Prepare the Installation Area

  1. Clean the trim: Thoroughly clean the areas where the trim pieces will be installed with isopropyl alcohol or a mild soap solution. This removes any waxes or oils that may interfere with adhesion. Allow to dry before moving on.
  2. Inspect the trim: Examine the trim pieces to ensure they are free of any defects or damage.

Step 2: Install Side Trim Pieces

  1. Start with the left side:
    • Align the bottom edge of the left side trim piece with the bottom edge of the truck bed trim, ensuring it's just inside the radius of the corner.
    • Peel back a small section of the backing and adhere the trim to the truck bed.
    • Continue peeling back the backing in small increments, using the squeegee to smooth out any air bubbles and ensure a secure bond.
    • Carefully align the trim around the cutouts for the crossbars and the control panel.
    • Repeat the process for the remaining sections of the left side trim.
  2. Install the right side trim:
    • Follow the same steps as for the left side trim, aligning the edges and using the squeegee to remove air bubbles.

Step 3: Install Top Trim Piece

  1. Access the truck bed: Enter the truck bed.
  2. Align the top trim piece: Align the top edge of the trim piece with the top edge of the truck bed trim, ensuring it's just inside the radius of the corner.
  3. Peel back the backing: Peel back a small section of the backing and adhere the trim to the truck bed.
  4. Smooth out air bubbles: Use the squeegee to smooth out any air bubbles and ensure a secure bond.
  5. Continue installation: Peel back the backing in small increments, using the squeegee to adhere the trim to the truck bed.
  6. Roll the edges: Gently roll the edges of the trim with your palm to ensure a tight seal.

Step 4: Install Corner Trim Pieces

  1. Peel and adhere: Peel off the backing from the corner trim pieces and adhere them to the respective corners of the truck bed.
  2. Smooth out air bubbles: Use the squeegee to smooth out any air bubbles and ensure a secure bond.

Step 5: Final Checks

  1. Inspect for air bubbles: Carefully inspect the entire installation for any remaining air bubbles. If any are found, gently peel back the affected area and re-adhere it.
  2. Check for alignment: Ensure all trim pieces are properly aligned and there are no gaps or overlaps.
  3. Check for adhesion: Gently press on the trim pieces to ensure they are securely adhered to the truck bed.

Tips and Troubleshooting:

  • Work in a clean environment: Minimize dust and debris to prevent particles from getting trapped under the trim.
  • Take your time: This is a meticulous process. Don't rush it.
  • If you encounter difficulties: If you have trouble with alignment or adhesion, gently peel back the affected area and re-position it.
  • Use a hair dryer: If the trim is difficult to work with due to cold temperatures, gently heat it with a hair dryer to make it more pliable.
Was this article helpful?
Yes
No