Xpel Armor All-Terrain Wheel DecalsUpdated 25 days ago

Please refer to the quick video below

If the Armor is curled after shipping, just lay it out flat(ish) for a few minutes and it'll soon flatten out.

Bellow follows an AI-generated step-by-step instructions.

• Preparation:

  • Park your Cybertruck in a clean, shaded area to prevent the solution from drying too quickly during application.
  • Thoroughly clean the rear bumper area to remove any dirt, dust, or debris. Use a microfiber cloth to ensure the surface is dry and free from contaminants.

• Create the Application Solution:

  • Fill a spray bottle with water and add a few drops of mild dish soap. This solution will allow you to reposition the film during installation.

• Position the Film:

  • Carefully remove the backing from the Xpel Armor film, exposing the adhesive side.
  • Generously spray the adhesive side of the film with the soap and water solution.
  • Align the film with the edges of the rear bumper, ensuring it covers the desired area. The solution will allow you to slide and adjust the film for precise placement.

• Apply the Film:

  • Once positioned correctly, use a squeegee or soft-edged tool to gently press the film onto the bumper surface.
  • Start from the center and work your way outward, pushing out any air bubbles and excess solution.
  • Be patient and methodical to ensure a smooth, bubble-free application.

• Finalize the Installation:

  • If necessary, use a heat gun or hairdryer on a low setting to gently warm the film, especially around curves or edges. This will help the film conform to the surface and enhance adhesion.
  • Allow the film to cure and adhere properly by avoiding washing the vehicle or exposing it to harsh conditions for at least 24 hours.