Molle PanelsUpdated 25 days ago
Please watch the quick video below, installation just takes a few minutes for each side.
Bellow follows an AI-generated step-by-step instructions.
Preparation:
- Park your Cybertruck in a clean, shaded area to prevent the solution from drying too quickly during application.
- Thoroughly clean the rocker panels to remove any dirt, dust, or debris. Use a microfiber cloth to ensure the surface is dry and free from contaminants.
Create the Application Solution:
- Fill a spray bottle with water and add a few drops of mild dish soap. This solution will allow you to reposition the film during installation.
Position the Film:
- Carefully remove the backing from the Xpel Armor film, exposing the adhesive side.
- Generously spray the adhesive side of the film with the soap and water solution.
- Align the film with the edges of the rocker panel, ensuring it covers the desired area. The solution will allow you to slide and adjust the film for precise placement.
Apply the Film:
- Once positioned correctly, use a squeegee or soft-edged tool to gently press the film onto the rocker panel surface.
- Start from the center and work your way outward, pushing out any air bubbles and excess solution.
- Be patient and methodical to ensure a smooth, bubble-free application.
Finalize the Installation:
- If necessary, use a heat gun or hairdryer on a low setting to gently warm the film, especially around curves or edges. This will help the film conform to the surface and enhance adhesion.
- Allow the film to cure and adhere properly by avoiding washing the vehicle or exposing it to harsh conditions for at least 24 hours.