Abstract Ocean Help Center logo
Abstract Ocean Help Center logo

All articles

Tesla Model 3

Installation guides for the Tesla Model 3 accessories

Categories

Tesla Refreshed Model 3 (aka Highland)

Installation guides for any products that are only made for the Refreshed Tesla Model 3 can be found here! Not sure if you have a 'refreshed' Model 3? If you have the factory ambient lighting and ventilated seats, then you have a Refresh!

1 article

Articles

Model 3 Installation Guides

Installation Guides for all Model 3's

Mudflaps for Model 3

Installation is a breeze! The video is shot with the wheels removed to help with the visuals, but there's no need to do that, in total the installation should take 10-15 minutes. Please watch the video to learn more.

Air Filter Magnetic Cover [1st Gen Console] for Model 3

Please refer to Tesla Raj's great video below.

Air Intake Vent Cover for Model 3

Open the frunkRemove the large plastic cover at the top of the frunk, near the windscreen/windshield. It just snaps on and off, no tools are needed.This reveals the intake for the AC; first try a 'dry fit' by placing the intake filter in place. If th

Trunk Lightbar in the Model 3

As with all of our lighting upgrades, this is plug-and-play, just take a couple of minutes to watch the video below. Jump to 3:40 for the install process.

Trunk and Frunk Sill Protector Set for Model 3

Please watch the short video for instructions on how to install.

Strut Upgrades for Model 3

As always, we recommend watching our videos below. This is an easy DIY project, but if you do not regard yourself as being a bit 'handy' (not handsy, that's entirely different) then this might not be for you. A big thanks to Brian at i1Tesla, as this

Trunk Hook for Model 3

This is one of the easiest, tool-free upgrades you can make, check out the video below for the how-to, and a demo of it's awesomeness!.

Door Bin/Pocket Lens Kit for Model 3

These just take a few seconds to install:. These are not designed for the rear doors, but fellow Tesla owner Sandy made a great post on how to gently bend them to fit, if you'd like to try that :-) Here's the link: https://teslamotorsclub.com/tmc/thr

Frunk Hooks

Supplied as a pair, with a small wrench to remove the bolt, these are easy to fit, simply remove the bolt, insert the hook ,and re-tighten the bolt. There's no need to over do it, hand-tight is fine, and do note that the hooks are supplied as a left/

Snap-in Air Intake Cover

This will just take a few seconds to install! Watch the 20 second video below, and ensure you hear a snap for each of the clips - if you don't, just apply a little pressure above the clip, and it'll snap right in.