Refreshed Model 3 & Y (aka Highland / Juniper)

Installation guides for any products that are only made for the Refreshed Tesla Model 3 can be found here! Not sure if you have a 'refreshed' Model 3? If you have the factory ambient lighting and ventilated seats, then you have a Refresh!

Trunk Sill Protector

Installation is easy, please watch the quick video below:. (applies to both the Refreshed Model 3 and Refreshed Model Y).

Center Console Wraps

Please refer to the video below, and take note of the following important points:.

Ultrabright Lights

Please refer to the video below. It's quite long, so please use the chapter markers to jump around.

B-Pillar Protection (PPF or Vinyl)

Please refer to the video below:.

Rear PPF Protection Kit

Please refer to the short video below.

Premium Mudflaps

Please refer to the short video below:.

Ultra-Premium Screen Protector for Refreshed Model 3

Please take a moment to watch the video below, it includes important tips and tricks for achieving a prefect installation!.

Wheel Center Hub Covers

So easy to install! Just stick the center cap on each hub cover, then push into each wheel to install. When applying the center caps, please apply firm pressure for 20 seconds (the 3M adhesive is pressure activated), and avoid driving in wet or cold

Refreshed Emblem

Please refer to the video below and use the chapter markers to jump to the section you need.

Retractable Charging Hub

Please refer to the graphic below:.

Steering Wheel Vinyl Wraps

Please watch the video below, and don't forget to freeze the vinyl before installing to make the process even easier!.

Window & Door Control Decals for Refreshed Model 3 & Y

This kit is fairly easy to install, but we really (really!) recommend you watch the video. Take note! All the usual rules apply for applying our vinyl products:.

Air Intake Cover

The vent covers snap in easily, so no video is really needed, but here's a 30 second overview just in case!.

Vinyl Wraps for Door Controls

Please refer to the video below for step-by-step instructions. It's recorded in a Model Y, but the process for the Refreshed Model 3 is essentially the same. As mentioned in the video, if you can put the vinyl in the freezer immediately prior to inst

Dash Wrap for Refreshed Model 3 & Y (Juniper & Highland)

Funny how a long strip of vinyl can instantly change the appearance of your Tesla. Just like that, you can liven up the appearance! Please watch the video below:.

PPF Protection for the Model Y Lightbar

Please refer to the video below.

Interior Vinyl Bundle

Please refer to the videos below. We recommend following them in order, as we've started with the easiest. Don't forget, if you can freeze the vinyl for a few minutes before installation, it helps with the installation, since it's less tacky and flop

Logo Inserts for Aero Covers

These are very easy to install, but please remember to clean the area first. Here's a quick video:.

PPF Door Sill Protectors with Wordmark

Please refer to the quick video below:. Prepare the area: Thoroughly clean the sill using the supplied slip solution. (Optionally) Apply the vinyl wordmark: Dry the sill, then carefully apply, aligning with the wordmark on the sill. (re)Apply slip so